Updated May 28, 2026 · Sino-Inst Engineering Team A magnetostrictive level gauge will deliver ±0.5 mm accuracy and resolve interface layers when four conditions are met: the float specific gravity matches the medium, the probe is mounted plumb, ferrous debris Read More
Updated May 28, 2026 · Sino-Inst Engineering Team There is no universal “best” radar level gauge. The selection collapses to four questions: what is the medium, how much beam clearance does the tank give, is contact (guided wave) allowed, and Read More
Updated May 27, 2026 | Sino-Inst Engineering Team A tank level monitoring system is not a single sensor — it is three layers: the level sensor, the 4–20 mA or HART signal, and the recorder or SCADA that turns the Read More
Updated May 26, 2026 | Sino-Inst Engineering Team A submersible pressure transducer measures the hydrostatic head of liquid above its diaphragm and reports it as a 4–20 mA, 0–5 V, or RS485 signal. Choosing one is not “pick the cheapest Read More
Contents Why Geometry Decides Accuracy Blanking Distance: Sizing the Dead Zone Five-Step Mounting Procedure Beam Angle and Clearance Math Avoiding False Echoes from Internals and Foam Outdoor Installation: Sun, Wind, Rain Commissioning: 6 Calibration Steps Common Installation Mistakes Ultrasonic Level Read More
Sulfuric acid storage tanks combine three measurement obstacles: corrosive vapor in the headspace, concentration-dependent material compatibility, and regulated overfill protection. Direct-contact float and capacitance probes corrode within months. Non-contact 80 GHz radar with the right antenna material handles 96-98% concentrated Read More
Blast furnace stockline measurement runs at 1200 °C inside, with dust, hydrogen-rich gas, and constant charging dynamics. Mechanical sounding rods and isotope sources have given way to 80 GHz FMCW radar as the standard since around 2018. This guide covers Read More
A water tank level sensor is the small instrument that turns “how much water is left” into a number a pump controller, PLC, or phone app can read. The right choice depends on tank material, fluid type (potable, rain, waste, Read More
An ultrasonic CO2 level indicator is a portable handheld tool that confirms how full a CO2 cylinder is without removing it from service. A technician presses the probe against the outside of the cylinder, runs it up and down, and Read More
An underground tank level indicator measures the liquid depth inside a buried tank — fuel, potable water, septic, or chemical — and shows it on a gauge, panel, or remote dashboard. The right indicator depends on the fluid, tank depth, Read More
